During the first part of our conversation with Dr. Roesler, we talked about the current state of on-orbit servicing, differentiated Gen One from Gen Two servicing, and spoke about what future generations of this technology will enable and why on-orbit servicing is in such high demand.

In the second part of our discussion, Dr. Roesler provided some additional details about the exciting and innovative capabilities that robotics can enable in space in the future, and how Gen One and Gen Two servicing may be just opening the door for some truly revolutionary services in space.

Here is what Gordon had to say:

Government Satellite Report (GSR): We’ve covered Gen One and Gen Two on-orbit servicing, but what does the future after those two generations look like?

Dr. Roesler: With the introduction of Gen Two capabilities, we’ll have access to dexterous robotics that can make something like changing out a reflector to address a new service area something that’s relatively easy to do. For example, the Dragonfly Project, a NASA-funded program, is intending to take reflectors and put them in place with a robotic arm on a commercial communication satellite.

So if you can put that in place with a robotic arm, you can also take it off again and put a different reflector on. That will give operators the ability to change the property of the satellite payload on-orbit. To better enable that, there are some easy things we could start doing to our new satellites that would allow us to take more advantage of robotic capabilities.

For example, NASA Goddard has developed a refueling quick disconnect. Today there are still many steps required to refuel a satellite, but this quick disconnect greatly cuts down that number of steps. That quick disconnect would have to be integrated into the satellite design before launch, but it’s not a painful installation and it could greatly facilitate the ability to transfer fuel.

Another new addition we should be considering adding to satellites during design and construction is the equivalent of a USB port on your laptop. It’s something DARPA has developed for the servicer, but it can also be installed on satellites before launch.  With a USB port, you can plug in to a thumb drive or hard drive and it recognizes what the component is and it provides new services. DARPA’s port will be used to hold the robotic tools on the servicer, but it also has power and data feeds just like a USB port. So you could bring up a new payload, plug it in, and take advantage of the power and communications of the host satellite.

That’s when you’re starting to get into Generation Three, which we haven’t discussed yet – modular satellites.

There is a tremendous amount of research and development that still needs to be done to create a truly modular satellite. But that research and development is extremely valuable because, if you have a modular satellite, you can take advantage of lower cost, more prolific launch systems that are being developed. Modular satellites would be assembled on orbit from components sent up on low-cost launches, or modules could be replaced in the future on a satellite that you already built and launched. That said, there would be a lot of testing that would need to be done on the ground and a lot of progress needs to be made.

The other revolutionary Gen Three capability is the assembly of large structures, such as antennas and telescopes, in orbit. NASA is working on in-orbit assembly for future astrophysics missions, on the premise that something large, like a 20-meter telescope, must be assembled in-orbit, due to the massive size of the hardware. In those instances, there is no way you could fold it into a single launch fairing – so [the hardware] would need to be assembled robotically in space.

In the same way, being able to assemble the largest reflector or antenna possible would give communication service providers significantly more flexibility.

GSR: Looking back at Gen Two capabilities and the addition of payloads to existing satellites, what types of payloads and capabilities could be added to a satellite in space with this technology? Why is this an attractive option for the military? For commercial operators?

Dr. Roesler: There would be many different possibilities. For example, one simple thing operators could do is to add cameras that provide the satellite the ability to see around it. In geosynchronous orbit, these satellites are 22,000 miles away and it’s difficult to see small objects. So if these cameras could see small objects close to the satellite, it would give operators the ability to react appropriately.

One other capability that could be added is space weather sensors. I mentioned earlier the consequences of not knowing what caused an outage. If you built a space weather sensor and attached it on-orbit, you’d have an indication of whether or not an outage was related to a solar event. There are also other ways of detecting nearby satellites that could be integrated into a small payload and attached.

The advantage of an attachable payload is that you don’t have to integrate it with a propulsion system and attitude control system. The cost is lower, it’s available for use faster, and the opportunities to get it on-orbit are more numerous.

For example, DARPA has developed a capability called PODS – which stands for Payload Orbiting Delivery Systems – that could carry a wide variety of separable mass elements to orbit – including attachable payloads – aboard commercial communications satellites. With 15 commercial launches to GEO a year, we can take advantage of such methods to get small payloads up there without having to buy entire launch vehicles.

In terms of commercial offerings for attachable payloads, many have told me that they are excited about the opportunity to host some of these payloads. It will produce a revenue stream for them for sure, but it also allows them to start thinking about other approaches for fleet flexibility. It’s also an entrepreneurial opportunity. There are people out there who want sensors for applications like agricultural use or environmental data collection, and some of these things can be done from GEO.

GSR: We often hear that concerns over timing – not having payloads built in time for launch – are a main reason why some agencies shy away from hosting payloads on commercial spacecraft. Could you see a reality where we put military or government payloads on commercial spacecraft on-orbit? Could this help alleviate some of those concerns and drive up adoption of hosted payloads?

Dr. Roesler: You really hit the nail on the head. Sometimes, secondary payloads, hosted payloads – or even the payloads for the primary mission – aren’t ready in time. The ability to add them after launch should be extremely freeing for the whole space enterprise and adds a tremendous amount of flexibility.

GSR: During the panel discussion, the panelists touched on the possibility of constructing satellites in space. Why would it be attractive to literally build or construct a satellite in space? What would that enable us to do that we can’t do with our current system of building satellites on Earth and launching them already constructed?

Dr. Roesler: One of the huge advantages is the reduction in testing and design requirements. If I’m going to launch something in pieces, I don’t have to worry about whether the entire assembly survives during launch – I only have to worry about whether the individual pieces survive. By testing at a lower level of integration, I’m saving costs and I’m saving time when I put them together on-orbit.

Another thing that approach lets you do is change your mind. Say you’re building numerous satellites and you have a choice of payloads and maybe you have a choice of power systems. If you have a modular architecture, you can change your mind about what a particular satellite is going to be in real-time. That’s basically unheard of now.

And, as I mentioned earlier, there’s this idea of taking advantage of smaller launch vehicles. There’s a group of investors today that are developing launch vehicles of much lower capacity than available medium-lift ones.  Similarly, DARPA is working on a launch system called XSP, which stands for Experimental Spaceplane, which is going to put 3,000-5,000 pounds into low Earth orbit. That mass range fills a gap between the very small launch vehicles and the larger ones. So by taking advantage of that emerging launch infrastructure that has a lot more variety to it, we get another reason to consider building satellites in orbit.

GSR: When it comes to all of these technologies and capabilities – on-orbit refueling, on-orbit servicing, adding payloads to existing satellites, building satellites in space – who is taking the lead in the development of these solutions?

Dr. Roesler: In the case of Gen One –life extension– it’s primarily industry. In the case of Gen Two– on-orbit refueling and on-orbit servicing– it’s definitely DARPA.

RSGS is a very large program dedicated to building a GEO robotic servicing vehicles and getting it on-orbit quickly. When I say that, I should also mention our commercial partner, SSL, who is building the bus and the ground segment and will eventually operate the satellite. And I should also mention the Naval Research Laboratory, which is responsible for all the advanced robotic work that’s leading to this capability. The technology is government-initiated, but we know that commercial players are eager to participate.

Then looking at Gen Three, I would say it’s a combination of DARPA, NASA, and industry. DARPA has some small projects centered around on-orbit assembly and also the idea of putting a persistent platform into GEO. One where payloads can come and go.

The analogy I like to use for such a platform is the antenna tower that you see along the highways. When you look at one of those towers, you’ll see a number of devices – cellphone antennas, point-to-point microwave, public safety radio antennas – all hanging on it. That’s because it’s cheaper to pay rent to the tower owner than it is to buy land and build a tower.

Obviously that makes sense in GEO as well. If you can just send up a payload to a persistent platform, you don’t have to worry about propulsion and attitude control. You have all that provided by the platform and you pay a fee to the platform operator for hosting your payload.

That’s really a win-win.

It could also provide flexibility, being able to swap the payloads more frequently and not have to worry about what the market is going to be like a few years from now.

If you missed part one of our two part conversation with Dr. Gordon Roesler, click HERE to read it in its entirety. For additional information on DARPA’s on-orbit servicing programs, click HERE.

The post In the future, we’ll build satellites in space – a Q&A with DARPA’s Gordon Roesler appeared first on SES Space and Defense.

Following that discussion, we reached out to Dr. Gordon Roesler, a Program Manager in DARPA’s Tactical Technology Office, who has been at the forefront of many of DARPA’s on-orbit servicing initiatives and programs. During our conversation with Dr. Roesler, we sought to learn more about how far on-orbit servicing technologies and capabilities have progressed, and to get a better picture of what on-orbit servicing can enable into the future.

In part one of our two-part conversation with Dr. Roesler, we talked about the current state of on-orbit servicing, what future generations of this technology will enable and why on-orbit servicing is in such high demand. Here is what Gordon had to say:

Government Satellite Report (GSR): Where does on-orbit servicing currently stand? Is this science fiction, or are we rapidly approaching a reality where satellites can be refueled and repaired in space? How long until we get there?

Dr. Roesler: As we move forward, there are going to be generations of servicing that offer increasingly sophisticated capabilities.

Generation One is what I call simple life extension, and there are already a couple of established players in that field. Effective Space is a UK organization that is building satellites that go up and dock with operating commercial communication satellites and help them maintain their positions and conserve their fuel, so that’s life extension through fuel conservation. Orbital ATK is doing something similar.

Generation Two is what DARPA is working on. We’re looking to use very sophisticated robotics to do things beyond just life extension. Using robotics, we’re looking to perform ultra close inspections, use robotic arms to repair satellites that aren’t functioning properly, or even perform upgrades – such as adding a new module to an operating spacecraft.

In terms of timing, Gen One is slated to launch in the 2018-2020 time frame and DARPA’s Gen Two servicer is going to launch in 2021.

I should also mention the NASA Restore-L effort, which blends Gen One and Gen Two technologies and capabilities. It’s a spacecraft that uses a DARPA robotic arm in order to refuel a NASA satellite. That’s effectively providing a Gen One service with a Gen Two technology.

GSR: What are the commercial benefits of on-orbit servicing? Why are commercial satellite operators interested in this capability?

Dr. Roesler: Let’s look at this in terms of the same Gen One and Gen Two breakout. When it comes to Gen One, life extension is a big reason for commercial interest. Life extension will provide an operator with fleet flexibility. Take, for example, SES, which has around 50 [satellites] in operation; if they can keep one of those on longer than was expected, they can shuffle the fleet around and provide services in a much more flexible way.

At the same time, this offers the benefit of minimizing capital expenditures by filling any gaps that might occur in the fleet without having to build an entirely new satellite. So the Gen One services are very valuable to commercial satellite operators.

Gen Two [on-orbit servicing] provides even more opportunity. Think about being able to bring up a new payload and attaching it to an existing satellite. Rather than having [to build] a new satellite to provide that capability, the operator only has to build a new payload. Not only does it defer capital expenditure, it actually reduces it.

This kind of idea of replacing payloads in-orbit also allows the operators to keep up with the needs of the terrestrial customer base. A satellite’s estimated life is around 15 years. That’s a long time to predict and understand what your customer base is going to look like or need. The ability to easily adjust the payloads in sync with customers can help keep the business case for that satellite alive.

Then there’s this idea of being able to perform repairs. About once every two years, a commercial satellite goes up and has some sort of deployment anomaly. If that could be repaired, not only does that allow you to recover the satellite capability faster than by building and launching a new spacecraft, but it also reduces insurance claims payouts. It’s really a win-win. So there’s a host of benefits from the development and introduction of Gen Two capabilities.

GSR: How do those benefits compare with the federal government and military? Are the benefits for them the same? Are there other reasons why they’re interested in this?

Dr. Roesler: Every one of those benefits that I mentioned also pertains to the U.S. government. The fleet flexibility, the reduced capital expenditures. We don’t have insurance companies, our insurance is from the taxpayers, so if we can save them the cost of a new satellite by repairing an anomaly, that’s a benefit as well.

There is also the ability to protect and provide resilience to our government satellites. An ultra close inspection with a robotic arm can help operators differentiate between an engineering flaw and a hostile act. So it could help to maintain rational behavior. When things fail and we don’t understand why they fail, we tend to be suspicious, that’s just the nature of it. This could alleviate that suspicion.

So there is a strategic benefit to this ultra close inspection. Also, there’s the benefit of being able to include new capabilities for protection of our existing satellites, as well as all the other benefits in terms of longevity and flexibility and repair.

Be sure to check back for part two of our conversation with Dr. Roesler, when we discuss the advanced capabilities that will be introduced via Gen Two on-orbit servicing, and what Gen Three could hold for the industry.

The post The progress and promise of on-orbit servicing – a Q&A with DARPA’s Gordon Roesler appeared first on SES Space and Defense.